![]() While doing troubleshooting on the FortiGate, it might be required to review traffic traversing the device from multiple addresses. This address can be either a source or destination address matching the debug flow.įGT # diagnose debug flow filter addr 10.1.1.1 Within a debug filter, a single address can be defined as well as multiple addresses. The following protocol numbers can be defined on the FortiGate. If there are several VDOMs configured, the vf value can be found as follows: If there are no VDOMs defined, the default value is 0. This is related to the different VDOMs configured on FortiGate. ![]() ![]() This article describes the smart use of filters to review the matched traffic traversing the FortiGate.īy default, there are no filters defined as can be seen in the output below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |